Contents

Operation and maintenance manual for Volvo VN and VHD

• General information
• VN and VHD model cab types
• Safety information
• Driving
• Entering and exiting the cockpit
• Transfer from driver's seat to sleeping compartment (standard gear lever)
• Seats, general
• Seat belts
• Seat belt inspection
• Important information about seat belts
• Airbag SRS
• Warning stickers
• Security equipment
• Collision avoidance system VORAD
• Instruments and controls
• Dashboard
• Toolbar
• Dashboard switches
• Steering column switches
• Steering wheel switches
• Tilt steering column
• Various switches
• Climate control systems
• Manual air conditioning system (MCC)
• Cab ventilation
• Sleeper cab air conditioning
• Sleeper control panel (sleeper models only)
• Parking heater (optional, sleeper models only)
• Interior lighting
• Antennas
• Radio receiver
• TV
• Communication equipment
• Driving
• Pre-trip inspection and daily maintenance
• List of pre-trip check-up procedures
• Daily maintenance
• Cab doors and door locks
• Electric door locks (optional)
• Central locking
• Heated mirrors (optional)
• Power mirrors (optional)
• Window regulator (optional)
• Landing gear / stair fairing open / closed
• Luggage compartment
• Hood
• Starting the engine
• Economy driving
• Honorable mention option
• How to work with the incentive bonus option
• Cold start and cold weather operation
• Engine operation
• Engine shutdown system
• Cruise control
• Immobilizer
• Active pressure maintenance cooling system (APCS)
• Information function
• Refueling
• Clutch
• Brakes
• Anti-lock braking system (ABS)
• Volvo stability technology
• Traction control system (TCS) (optional)
• Vehicle speed deceleration devices
• Cummins engines (optional equipment)
• Power steering
• Fifth wheel overview
• Fifth wheel coupling
• Fifth wheel slider (optional)
• Opening the fifth wheel
• Trailer coupling
• Unhitching the trailer
• Hitch slider
• Bridges
• Luggage sections
• Sleeping places
• Ventilation of sleeping cabins
• Cab models VN 780, VNL 730, VN 670
• Sink in the sleeping area
• Cab equipment
• Maintenance and lubrication
• Towing
• Releasing the spring brake chambers
• Towing a vehicle with AIRTEK suspension
• Wheels
• Electrical system
• Front bumper / number mount
• Air fairing
• Car design changes
• Cab air filters
• Lubrication

Volvo D11F and D13F engines operation manual

• Engine storage
• Engine components, service diagram
• Cooling system
• General information about coolant
• Additives
• Coolant change intervals
• Filter replacement intervals
• Extended life coolant filter change intervals
• Fuel system
• Safety instructions
• Diesel fuel specification
• Fuel filters
• Engine oil
• Oil filters
• Engine air filter
• Fan and auxiliary drive belts
• Turbocharger and charge air cooler
• Fuel system service

D12D engine operating instructions

• Engine components
• Vectro III user parameters, D12D engine
• D12D engine options
• Standard engine equipment
• Additional engine equipment
• Engine preservation
• Starting the engine after a long period of inactivity
• Cooling system
• General information about coolant
• Water characteristics
• Testing standard antifreeze
• Fuel system
• Safety instructions
• Diesel fuel specification
• Fuel additives
• Engine oil
• Service schemes for VN, VHD models
• Service
• Flushing the cooling system
• Turbocharger and charge air cooler
• Replacing fuel filters

Operating instructions for engines D16F

• Engine preservation
• Safety technology
• Engine components, service diagram
• Cooling system
• General information about coolant
• Fuel system
• Diesel fuel specification
• Fuel filters
• Engine oil
• Engine air filter
• Diesel particulate filters
• Fan and auxiliary drive belts
• Turbocharger and charge air cooler
• Fuel system service

Cummins ISM engine operation manual

• General information
• Engine specifications
• Operation manual
• General information
• Normal startup order
• Engine operation rules
• Engine braking system
• Electronic fuel system
• Description of the ISM fuel system
• Maintenance
• Daily service
• Service after 24,000 km (15,000 miles) (300 hours or 6 months)
• Fuel filter (keyed)
• Lubricating oil and filters
• Cooling system filter
• Additional frost resistant coolant additives (SCA)
• Service after 192,000 km (120,000 miles) (3,000 hours or 2 years)
• Automatic belt tensioner
• Engine equipment (overhead camshaft)
• Service after 385,000 km (240,000 miles) (6,000 hours or 3 years)
• Cooling system
• Antifreeze
• Oscillation damper
• Air compressor
• Adjustments and repairs
• Cooling fan belt, fan
• Alternator drive belt
• Cooling system thermostat
• fan drive intermediate pulley
• Fan hub, drive belt
• Automatic belt tensioner
• Engine systems diagrams
• Symptomatic troubleshooting
• Maintenance Specification
• Recommendations and specifications for fuel
• Recommendations and specifications for engine oil
• Operating the engine in arctic conditions
• Coolant recommendations and specifications
• Ready-to-use coolant / antifreeze
• Additional coolant additives (SCA)
• Set CC-2602 for checking the concentration of SCA additives
• Checking the coolant
• Coolant change requirements
• Values ??of tightening torques of engine units and components
• Bolt markings and tightening torques
• Tensioning the drive belt

Cummins ISX engine operation manual

• Engine identification
• Engine specification
• Operating instructions
• Normal engine start
• Fuel shut-off valve
• Low temperature engine operation
• Starting the engine at low temperatures using starting fluid
• Means to facilitate starting and engine operation at low temperatures
• Engine operation rules
• Engine operating range
• Stopping the engine
• Engine braking system
• Electronic fuel system
• Diagnostic trouble codes
• Cruise control
• Power take-off operation
• Idle speed cut-off function
• Climate system ICON
• ICON TM system launch
• Keeping the temperature in the cab
• Shutting down the ICON TM system
• ICON TM programmable modes
• Cab thermostat operation
• ICON TM system idle speed control
• Notes on trouble codes
• Daily maintenance
• General information
• Water separator
• Lubricating oil level
• Coolant level
• Radiator fan
• Drive belts
• Air intake piping
• Charge air cooler air line
• Air receivers and tanks
• Crankcase breather pipe
• Maintenance operations after 32,000 km (20,000 miles) or after 625 operating hours or 6 months of operation
• General information
• Lubricating oil and oil filters
• Filling engine oil
• Additional Coolant Additive (SCA)
• Maintenance operations after 80,000 km (50,000 miles) or 1,500 hours or 1 year of operation
• General information
• Coolant filter
• Fuel filter (easily removable cartridge type)
• Automatic belt tensioner
• Air leaks in the air intake and exhaust system
• Mounting gasket for turbocharger and exhaust manifold
• Turbine housing seal surface
• Compressor casing seal surface
• Checking the air filter clogging
• Engine Wiring
• Maintenance operations after 200,000 km (125,000 miles), every 3,000 hours or 2 years of operation
• General information
• Engine Hoses
• Means to facilitate engine starting during cold seasons
• Engine mounting bolts
• Crankcase breather pipe
• Vibration damper
• Maintenance operations after 800,000 km (500,000 miles), every 10,000 hours or 5 years of operation
• Belt driven fan hub
• Carbon deposits in an air compressor
• Air Compressor Release Check
• Adjustment of valve clearances, injectors, engine brake
• Complete engine brake
• BRAKE SET setting marks
• Pneumatic starter
• Battery cables & connections
• Turbocharger
• Long-term preservation of the engine
• Functional diagrams of engine systems
• Functional diagrams of engine systems - general information
• Fuel system
• Lubrication system
• Cooling system
• Air intake system
• Exhaust system
• Circulation diagram, pneumatic system
• Troubleshooting
• Troubleshooting tables
• Maintenance specification
• Specifications
• Cummins / Fleetguard ® / Nelson filter specifications
• Recommendations and specifications for fuel
• Recommendations and specifications for engine oil
• Operating the engine in arctic conditions
• Coolant recommendations and specifications
• Ready-to-use coolant / antifreeze
• Fleetguard® Nelson® DCA4 replacement filters & liquid additives
• Additional coolant additives (SCA)
• Set CC-2602 for checking the concentration of SCA additives
• Checking the coolant
• Coolant change requirements
• Values ??of tightening torques of engine units and components
• Bolt markings and tightening torques
• Tensioning the drive belt

Volvo D12 engine repair

• Tightening torques for screw connections
• Engine repair
• Removing and installing engine
• Compression test in cylinders
• Cylinder head
• Valves, removal and installation
• Pistons and liners, replacement
• Rocker arm, overhaul
• Camshaft, wear check
• Camshaft replacement
• Flywheel, check
• Flywheel replacement
• Flywheel sensor, distance, check
• Flywheel ring gear, replacement
• Flywheel bearing, replacement
• Crankshaft oil seal, replacement (rear)
• Removing and installing oil pump
• Replacing the oil filter
• Replacing the pressure reducing valve
• Fuel System Bleed
• Replacing the fuel pump
• Replacing the fuel filter
• Replacing the water separator filter
• Replacing the feed pump valves
• Replacing the bypass valve
• Replacing unit injectors
• Replacing the turbocharger
• Cooling system cleaning
• Replacing the turbo compound (D12D500 engine)
• Turbo compound drive replacement (D12D500 engine)